GRBL 1.1 3 Axis Control Board Dual Y-axis USB Driver Supports 500W/300W Spindle

Description

GRBL 1.1 3 Axis Control Board Dual Y-axis USB Driver Supports 500W/300W Spindle
Features: 100% brand new and high quality
Power supply: DC12-48V, Spindle: 48V 0-500W
Stepping motor: X/Y1/Y2/Z; Fan: 12V
Connect the laser: 2pin/3pin/2pin-2pin; Connection: USB cable
Support: servo/offline controller/limit switch
The motor driver module is with under voltage protection to prevent instantaneous large current from damaging the module.
Specification: Material: P CB
Size:13x8.6cm/5.11x3.38inches
Color:As Picture Shown
The spindle motor and laser cannot be connected at the same time
The offline control board and the SUB data cable cannot be connected at the same time
Turn on the power after the electrical connection is complete
The positive and negative poles of the input power supply must not be connected reversely, it will burn out if connected reversely
The 48VDC interface cannot be connected to the switching power supply, and the voltage that the DC base of the control board can pass cannot be greater than 5A
Package Includes: 1x Motor Driver
note: 1.Please allow 1-2cm errors due to manual measurement, make sure that you do not mind before you order.
2.Due to the difference between different monitors, the picture may not reflect the actual color of the item.