CNC NEMA 34 Stepper Motor 1600oz-in 3.5A & Driver & Power

Description

The item includes:
1 PC Nema 34 Stepper Motor with 1600oz-in holding torque for
Dual shaft
,
1 PC DQ860MA with 7.8A peak current ,24-80VDC ,256 Microstep
1 PC Power Supply for  350W,60VDC,
1 PC Breakout Board
1 PC DB25 Cable
The Breakout Board is offered to you for free to buy this item above, so that you can set this kit up, and work in better condition.
[email protected]
/
[email protected]
1, Stepper Motor
Technical Specifications
Part No.:                      WT85STH151-3004B (85BYGH450C-012B)
dual shaft
Frame Size:                NEMA34
Step Angle:                 1.8 degree
Voltage:                       5.7V
Current:                       3.5A/phase
Resistance:                 1.9 Ohm/phase
Inductance:                 22 mH/phase
Holding torque:          11.2N.m
1600oz-in
Rotor inertia:               3600g-cm2
Number of wire leads: 4
Weight:                          5 kg
Length:                         151mm
Note: Nema 34 Stepper Motor with 1600oz-in holding torque on  dual shaft, front shaft length is 37mm with 25mm flats length, the rear shaft length is 34mm with 25mm flats length, the diameter for motor shaft is 14mm.
RED           A+
GREEN      A-
YELLOW    B+
BLUE         B-
Please tell us if you need Double shaft or single shaft, we can manufacture both for you. If you need Double shaft, please tell us your requirements for length of front and rear shaft, as well as the diameter. So that we can offer you the quite good products, thanks!
2, Stepper Motor Driver DQ860MA
Introduction,Features and Applications
Introduction
The DQ860MA is  an economical microstepping driver based on patented technology of Wantai Motor .It is suitable for driving 2-phase 4-phase hybrid stepping motors .By using the advanced bipolar constant-current shopping technique ,it can output more speed and torque from the same motor,compared with traditional drivers ,such as L/R drivers .Its 3-state current control technology allows coil currents to be well controlled and with relatively small current ripple,therefore less motor heating is achieved.
3, Power Supply-350W,60VDC,5.83A
4, Breakout Board
Description:
Built in DB25 male connector.
DB25 Output Pin:P1,P2,P3,P4,P5,P6,P7,P8,P9,P14,P16,P17.
DB25 Input Pin: P10,P11,P12,P13,P15.
DB25 GND Pin: P18-P25.
Power supply: +5V DC.
Built in C-class Optical-coupler.
High quality with Surface-mount Tech.
We ship worldwide!
Our Products are mainly used in robotization, Spinning Automatization, Printing, Packing, Medica   Machine, Make-up Equipment, Communication,    Household Appliance, Water Pump, Milling Machine, Engraver Machine, CNC Routers.. etc automatic equipment of various trades.