CNC Assembled 10ft. 2.2Kw VFD Cable (Built With 16/4 Double Shielded Cable)

Description

Please review the entire listing, and all videos carefully to understand the gravity of this package.
DO NOT ORDER THIS CABLE IF YOU DO NOT HAVE A Black 15.5mm DIAMETER CONNECTOR HY USES DIFFERENT CONNECTORS FOR ALL THEIR SPINDLES. THIS MEANS EVEN A 2.2kW CAN HAVE A DIFFERENT CONNECTOR. SEND ME A PICTURE TO CONFIRM YOURS IS THE SAME TO AVOID LOST TIME AND MONEY WITH RETURNS
This listing is for a
completely built ready to plug in
CNC spindle cable for your HY your spindle.
This cable is built using the following components below.
10Ft.
piece of 16AWG 4 lead
Double Shielded Robotics
Grade Spindle Cable. (
This cables outer diameter is 10.5mm with a minimum bend radius of 3.5in
)
13mm diameter (
600v 125c
)
temp rated heatshrink (
single wall for flexibility
)
(
T
his is to build your VFD's end boot that goes around your leads
).
13mm diameter (
600v 125c
)
temp rated heatshrink (
double wall
with adhesive
) (
This is for  the spindle connector's end termination
)
4 4mm solder type ring connectors with 4 matching pre-cut 3mm (
600v 125c temp rated
) heatshrink pieces for insulation to provide proper VFD end termination
18awg green silicone drain wire (
200c temp rated
)
This cable is rated to
600v, and 105 degrees Celsius (221 degrees Fahrenheit)
This cable is designed for your spindle to VFD connection to protect your CNC system from EMI penetration. This cable is professional Robotics grade, and features both Mylar foil, and tinned braided copper shielding with twine separator in the center of the four conductors, and
16awg ground drain lead for the minimal electrical resistance
.
The conductors are also tinned braided copper for maximum conduction.
The amp rating chart below reflects the cables capacity based on the conductors insulation rating temperature.
I can offer this cable in any size you require. Please message me for pricing.
This cable ships UPS ground delivery for US orders.
Expedited shipping is also available please message me for pricing to your location.
Eliminate EMI signal contamination from the beginning making your system "Bullet Proof" with the proper cable.
Please review the video below for an overview of me discussing this component to know exactly what your purchasing.
The video below is the overview on the cable's overview, and assembly.
Assembled 2.2Kw Spindle Cables In Custom Lengths...
Video will open in a new window
Using the eBay App? Paste link into a browser window:
[isdntekvideo]
CNC Spindle Cable DIY Kits With All Required Accessories To Assemble... - YouTube
Video will open in a new window
Using the eBay App? Paste link into a browser window:
[isdntekvideo]
Spindle Cable Rev2 Updates (No Cost Increase)... - YouTube
Video will open in a new window
Using the eBay App? Paste link into a browser window:
[isdntekvideo]
Please understand there's no warranty on the cable after an end user installs it in their CNC system, as then all cables in your robot are then considered end user consumables as once they've been put in service successfully for any length of time as it's naturally impossible for me to determine its service life based on its installation, usage, servicing ect.
All my international orders are handled through eBay's Global Shipping Program as they offer us both the best protection against loss, and damages. Please review their policy for a shipping quote based on your specific location as they don't disclose it to me.